Features:Brand new and high quality.
Extrusion: hot melt extrusion molding accumulation.
Print Range: indefinite
Spinning Speed: adjustable
Heating temperature in the range: 160- 250 degrees Adjustable
Device operating voltage: 12V 3A
Nozzle: 0.4 mm
Prolonged use doesn't cause FLAC fatigue
The product is lightweight design: a slim(easy to handle)design.Currently on the market there are several 3D stereoscopic pen,but they are not very comfortable to use i.e bulky,heavy weight,is not conducive to hold control operation.We believe that the design is the closest you can get to USER-Friendly requirements and anti fatigue.
Control: For some of the design and operation of three-dimensional defects pen on the market,we believe our pen provides users to operate when arbitrary. Unfortunately,the current products on the market,have no speed control function, or have a simple switch for speed dial, or even just the speed control switch as an ornament,no practical purpose.Even if there is a file with a speed dial,you must advance or use your hand to control.You lose the true meaning of the design.You can freely control it according to the hand speed,allowing users in the creation of real time three-dimensional painting done most practically and with ease.
Heating coil and a nozzle cartridge design. In the development stage, we compared the purchase of several products on the market and found these products in the strict sense, is a failure of design , in terms of appearance and use , most importantly, the future users of the product during the replacement of wearing parts and maintenance of great distress . If the heating coil burned out, or nozzle clogging , the user must own bare hands to break up the replacement of the entire product , and deadly is unreasonable due to internal design , users can often open later and then put back . It took three or four hundred or even six or seven hundred to buy back, as long as the bad results would lead to a part failure. This is intolerable by