This version of the MCP4725 Breakout fixes a few issues with the board including the IC footprint,
the I2C pinout, changes the overall board dimensions to better fit your projects, and a few more minor tweaks.
This board breaks out each pin you will need to access and use the MCP4725
including GND and Signal OUT pins for connecting to an oscilloscope
or any other device you need to hook up to the board.
Also on board are SCL, SDA, VCC, and another GND for your basic I2C pinout.
Additionally, if you are looking to have more than one MCP4725 on a bus,
the pull-up resistors on this board can be disabled just check the Hookup Guide in
the Documents section below for instructions and tips on doing this.
I2C Interface (Standard, Fast, and High-Speed supported)
2.7V to 5.5V supply
Internal EEPROM to store settings
1 x MCP4725 I2C DAC Breakout Board 12-Bit DAC w/I2C Interface GOOD
MCP4725 I2C DAC Breakout Board module 12-Bit DAC w/I2C Interface GOOD